Appliance Repair in Edmonton

Local technicians who live and work here — same-day repairs across Mill Woods, Windermere, Downtown, West Edmonton and every neighbourhood in between.

Canadian flag Proudly Canadian owned & operated
Appliance repair in Edmonton

Local

Technicians from your community

$0

Service fee with repair

90

Day repair warranty

All

Makes & models serviced

We Repair All Major Appliances

Fridge Repair

When a fridge stops cooling, every hour is a race against spoiling food, so we start with a real diagnosis before touching a single part. On arrival our technicians check the sealed system, defrost circuit and airflow, pinpoint the real fault, and most often have it holding temperature again the same visit. We take these calls right across the southwest, including Windermere and Terwillegar.

What We Fix

  • Not cooling while running — compressor, start relay or sealed system
  • Frost buildup or water under the crispers — defrost system
  • No ice or a jammed dispenser — icemaker and water valve
  • Warm interior with condensation — worn door seals
  • Uneven temperatures between compartments — evaporator fan or sensor
Book a repair
Refrigerator repair Edmonton

Washer Repair

A washer that stops mid-cycle leaves you with a locked door, a full drum and water on the floor all at once. We drain and unlock it first, then explain exactly what failed and quote the full repair before any parts come out — no guesswork, no surprise charges at the end. Calls from Strathcona and Bonnie Doon make up a good share of our week.

What We Fix

  • Won't drain — clogged pump, filter or kinked drain hose
  • Won't spin or shakes hard — unbalanced load, bearings or suspension
  • Grinding or screeching on spin — worn tub bearings
  • Won't lock or leaks at the door — latch or gasket
  • Slow fill, no water or overfilling — inlet valve or pressure switch
Book a repair
Washing machine repair Edmonton

Dryer Repair

Most dryer faults trace back to heat or airflow, and a clogged vent is both a performance problem and a fire hazard. Alongside the repair itself, we clear and inspect the full exhaust path on every visit and flag anything unsafe on the spot, before it turns into a bigger problem. It's the same thorough check whether you're in Mill Woods or Summerside.

What We Fix

  • Tumbling but not heating — element, thermal fuse or gas igniter
  • Long drying times — restricted vent or weak blower
  • Drum won't turn or squeals — belt, rollers or idler pulley
  • Shuts off mid-cycle — thermostat or thermal cut-off
  • Won't start — door switch, thermal fuse or control board
Book a repair
Dryer repair Edmonton

Dishwasher Repair

A struggling dishwasher quietly runs up your water bill and can leak behind the cabinets long before you notice. We trace each symptom back to its real root — drainage, spray pressure or worn seals — so the repair holds instead of coming back a month later. Homeowners in Glenora and Crestwood call us for exactly that kind of lasting fix.

What We Fix

  • Standing water or won't drain — pump, filter or check valve
  • Dishes still dirty — wash pump or clogged spray arms
  • Wet dishes at cycle end — heating element or vent fault
  • Leaking onto the floor — door gasket, latch or hose
  • Won't start or trips an error — control board or float switch
Book a repair
Dishwasher repair Edmonton

Stove Repair

Cooktops mix gas and high voltage, so they're the last appliance you should improvise on. We repair gas, electric and induction tops to code, test every connection before we leave, and never walk away from a safety issue. That standard holds for every kitchen we work in, Downtown and out to Westmount alike.

What We Fix

  • Gas burner clicks but won't light — igniter or spark module
  • Weak or yellow flame — burner ports or gas valve
  • Electric element won't heat or heats unevenly — element or switch
  • Induction won't detect pans or cuts out — coil or sensor
  • Dead or unresponsive controls — knobs, switches or control board
Book a repair
Stove and cooktop repair Edmonton

Oven Repair

A few degrees off the dial can ruin what took hours to prep, and most ovens drift without anyone noticing. We measure the real cavity temperature with a calibrated probe, replace whatever's drifting, and verify it against your setpoint before we sign off. Households around Riverbend and Rutherford count on that accuracy every day.

What We Fix

  • Won't reach or hold temperature — sensor, element or control
  • Bakes unevenly or with cold spots — bake/broil element
  • Convection not circulating — fan motor fault
  • Heat escaping, slow preheat — door hinges or seal
  • Error code or gas oven won't light — igniter or control board
Book a repair
Oven repair Edmonton

Brands we service

From LG to Whirlpool — we repair every major brand across Edmonton, with genuine parts and a 90-day warranty.

A few things worth checking first

Quick, safe things you can check yourself in a couple of minutes. If it's still not right, we'll take it from there.

  • Set the temperature dial to about 3°C in case it got bumped
  • Check the door shuts fully and nothing inside blocks the seal
  • Vacuum the dust off the coils at the back or underneath
  • Don't overpack it, cold air needs room to move around

Still warm after a few hours? That's a repair.

  • Redistribute the load, an unbalanced drum won't spin
  • Make sure the door or lid is fully latched shut
  • Check the drain hose at the back isn't kinked or pinched
  • Clean the filter behind the small panel at the front bottom

Still won't drain or spin? Book a repair.

  • Clean the lint filter, every single load, without fail
  • Check the vent flap outside the house opens freely
  • Give clothes room to tumble, don't overload the drum
  • Make sure the door clicks fully shut before it starts

Still damp after a full cycle? We'll take a look.

  • Clean the filter at the bottom of the tub
  • Check the spray arms spin and the holes aren't blocked
  • Run the kitchen tap hot before you start the cycle
  • Make sure the drain hose isn't kinked behind the unit

Still not draining or cleaning? Book a visit.

  • Unplug it for a minute to clear a stuck demo mode
  • Check the door closes and seals properly all around
  • Confirm the real temperature with an oven thermometer
  • Position the racks so heat can move around the food

Still not heating or way off? That's a tech job.

  • Reseat the burner caps and wipe the ports dry after spills
  • Push the knobs in and turn fully through each setting
  • Induction: use induction-ready cookware only
  • Smooth-top: wipe residue off the surface for good contact

Burner still won't light? We handle gas, call us.

These are safe, surface-level checks. Anything behind a panel, a gas line, or wiring should always be left to a technician.

Tried these and it's still not right?

No problem, that's what we're here for. Book a visit and we'll get it sorted.

Book Now

Reviews from your neighbours

Real homeowners across the Edmonton area, in their own words.

MF

Megan Fowler

2 weeks ago

★★★★★

Came down one morning to a fridge that had quietly given up overnight, everything inside already warm. They squeezed me in that afternoon and had it cold again before dinner. Genuinely relieved.

HG

Harjit Gill

1 month ago

★★★★★

What I appreciated most was not being pushed toward a new machine when a repair would do. He laid out the options, gave me the price up front, and that was that.

TB

Tyler Brennan

3 weeks ago

★★★★★

Our dryer had been taking two runs to dry a single load for ages and I'd just learned to live with it. Turned out the venting was packed solid. It dries in one cycle now, and he flagged that it was a fire hazard.

ST

Sophie Tremblay

2 months ago

★★★★★

Booked online in the evening, someone was here the next morning, dishwasher draining properly by lunch. Hard to fault any of it.

EN

Emeka Nwosu

6 days ago

★★★★★

Water was pooling under the washer every wash and I kept blaming the hose. He found it was the door seal, swapped it, and mopped up after himself too. Floor has been dry since.

AR

Anjali Rao

5 weeks ago

★★★★★

Everything was coming out either burnt or half-raw and it was driving me up the wall. He worked out the oven was running well off temperature, recalibrated it, and now it bakes evenly again.

DP

Doug Petersen

2 months ago

★★★★

Solid work on our gas stove, burners lighting first try again. Only reason it's not five stars is we waited a couple of extra days for a part, but the fix itself was spot on.

GK

Grace Kim

4 days ago

★★★★★

Called on a Saturday half expecting voicemail and they still found me a slot. Quick, polite, and clearly knew the area. Would call again without thinking twice.

MB

Marco Bianchi

7 weeks ago

★★★★★

A small issue cropped up a couple of weeks after the first visit and they came straight back under warranty, no charge and no fuss. That kind of follow-through is rare these days.

1 / 3
2 / 3
3 / 3

Book your repair

Three simple steps — most repairs are booked in under two minutes.

1

You book

Fill in the form or give us a call. Tell us the appliance and your city — that's it.

2

We confirm a time

Our operator calls you back, agrees on a time slot that works, and locks it in.

3

Technician at your door

A local certified tech shows up on time, diagnoses, and fixes it — usually the same visit.

Get in Touch

Fill out the form below and we'll get back to you soon.